If you were commissioned to look for options to increase the reception of cell phones in your company or company, you probably found it to be a difficult task. Firstly, it is very likely that you were given a budget that is too small or almost zero. This is because the market is flooded with so many accessories for low-end consumer mobile phones that anyone can buy them at a local electronics store for less than $ 300 that many people really have no idea what they are. You need to increase cell phone coverage for the entire building. Secondly, to work within this budget, you may have to make difficult decisions. Am I trying to cover Verizon and AT&T? What about Sprint and T-Mobile? Do we also need 4G LTE coverage or just voice and 3G? Thirdly, you probably wondered: “Is this something we can do ourselves, or do we need to hire an engineer to develop the system and an external contractor to install it?” Well, my friend, you came across an article that going to make your job a million times easier.
However, due to all the new FCC rules regarding cell phone signal amplifiers, the new version will cover only part of this. The original design is still available, but it can only be purchased and installed if your provider (s) gives you explicit permission (the number of confirmations was very low, as my sources say), and it needs to be professionally installed and configured.
Inconveniences associated
Despite the fact that the FCC is associated with many inconveniences associated with the consumer signal amplification industry, the main advantages are ease of installation and confidence that it is impossible to intervene in the networks of operators. All new consumer signal amplifiers of 2014 should be sold as a set, which means that you do not need to be an engineer to develop a system that covers your building, and anyone can install it. The main obvious disadvantage is the limited coverage of one system. However, several systems can be installed in the same building for timely coverage, and since all new amplifiers are designed to shut off in case of interference problems, the operator’s network is not dangerous. Just move the antennas, which can interfere with each other, from different systems, and everything is in order.
So, how do I know if the amplificateur signal 4g cell phone signal amplifier is right for my company?
If your business is up to 25,000 square feet. And you constantly have employees who hang up important phone calls or complain about their low data rate, but have a relatively decent external signal, Force5 is for you. Force5 will support up to 100 concurrent users and is operator independent, which means that it will work for all major operators and their voice and data technologies.